Made In Great Britain

Direct from our factory

Product Test Results

All test results published

Expert Technical Advice

Call or chat with our team

Testing

Testing

Gloss Value

A gloss value tells you how shiny a cured finish is. It is a measurement of appearance, taken with an instrument, so two finishes can be compared by number and not by eye. What the test measures Gloss is the...

Read more

Light Reflectance Value (LRV)

Light reflectance value, or LRV, is a number for how light or dark a finished colour is. It belongs to the colour and finish, not to the product, so each colour in a range has its own figure. What the...

Read more

Adhesion (Pull-Off)

A pull-off test measures how firmly a coating is bonded. A metal disc is glued to the cured film and pulled straight off. The force at failure, and the place the failure happened, are the result. What the test measures...

Read more

Slip Resistance (Ramp Test)

The ramp test produces the R ratings seen on flooring data sheets, from R9 to R13. A person walks on a sample of the floor while it is tilted, and the angle at which they slip sets the class. What...

Read more

Water Permeability (Capillary absorption)

Masonry and concrete are porous. Left bare, they draw water in by capillary action, the way a sponge does. This test measures how far a coating cuts that down. What the test measures The test measures the rate at which...

Read more

VOC Content

VOC stands for volatile organic compound. In a coating these are mostly the solvents that evaporate as the film dries. VOC content states how much of them the product contains. What the test measures The test measures the mass of...

Read more

Flexibility (Mandrel Bend Test)

Surfaces move. Timber swells and shrinks, sheet metal flexes, and everything expands in the sun. A coating has to move with the surface or it cracks. The mandrel bend test measures how much bending a film takes. What the test...

Read more

Scratch Resistance (Sclerometer)

A scratch is a single line of damage from one hard point: grit under a boot, the corner of a pallet, a dropped tool dragged aside. The sclerometer test measures the force it takes to make one. What the test...

Read more

Chemical Resistance

No coating resists everything. Chemical resistance testing shows which substances a cured film withstands, at what strength, and for how long. What the test measures The test records the effect of a liquid on a cured coating after a set...

Read more